Every Session Answers a Distance Question
We do not sell a generic “fitting.” Each service below exists to answer a specific question about what your bag can and cannot cover. Pick the one that matches the shot you keep having to invent.
The Full-Bag Gapping Audit
This is the session we recommend when nothing in particular is broken but the whole set feels approximate. Every club you own goes on the gauge table, then on the monitor, and we plot the carry ladder end to end. You leave with a printed map of your distances and a list of the specific changes that would even it out.
It takes about two hours because measuring fourteen clubs takes about two hours. Most people find at least one gap over eighteen yards and at least one pair of clubs flying the same distance.
What it is not. This is a measurement session, not a lesson. We will tell you what your clubs do. We will not try to change your swing while you are on the mat.
Single-Club Sessions
Ninety minutes each, focused on one part of the bag. These are the right choice when you already know where the problem is.
Wedges
Loft spacing, bounce, grind, and length across the scoring clubs. Includes turf-strip testing.
DetailsIrons
Head style, shaft weight, length and lie, plus a check that the steps between clubs stay even.
DetailsDriver
Loft, face angle, weight placement and shaft, worked in that order rather than shaft first.
DetailsFairway Woods
Sole width and loft chosen for the lies you actually face, with tee performance treated as bonus.
DetailsHybrids
Sized to a specific yardage hole rather than added by default at the top of the set.
DetailsPutter
Length, lie, and head weight measured from your own address position on the bentgrass strip.
DetailsBench Work Without a Fitting
Not everything needs a session. Plenty of golfers come in for a single job and are out in under half an hour.
| Job | Turnaround | Notes |
|---|---|---|
| Loft and lie check | Same visit | Whole set measured and recorded |
| Bending | Same visit | Forged heads only; cast heads case by case |
| Re-gripping | Same day | Grip stock held in four core sizes |
| Re-shafting | 1–2 days | Includes swingweight re-match |
| Shortening or extending | Same day | Swingweight corrected afterward |
| Junior re-size | Same day | Cut down and re-weighted as they grow |
Seasonal Work
Two things we push people toward at fixed points in the year. In March, a cold-weather carry check, so the numbers you are playing to in April are the numbers your clubs actually produce in April. In October, a wear inspection on the scoring clubs, because groove condition after a full season is the single most under-checked spec in golf.
Both take under an hour and both are cheaper than the shot you will misjudge without them.